Why my CERTIFIED 060-3742-2 engine fails to start?
If the CERTIFIED Snow Blower engine fails to start, it could be due to a flooded engine. Try repeating the start attempts with the throttle choke OFF. Another cause might be water in the fuel, in which case you should drain the tank and refill it with fresh fuel. If those solutions don't work, check carefully the start procedure according to this manual.
What to do if the auger does not rotate on my CERTIFIED 060-3742-2 Snow Blower?
If the auger of your CERTIFIED Snow Blower does not rotate, it could be because foreign material is caught in the system, so clean it. Alternatively, the auger drive belt might be slipping, so adjust the belt and wire. If the belt is broken, replace it. If the auger control cable is out of adjustment, see ADJUSTING AUGER CONTROL CABLE section.
How to fix a CERTIFIED 060-3742-2 auger that won't stop?
If the auger of your CERTIFIED Snow Blower does not stop when the lever is released, it could be because the auger drive belt is out of adjustment, so adjust the belt. Another possible cause is that the auger drive guide is out of adjustment, so adjust the guide. If the auger control cable is out of adjustment, see ADJUSTING AUGER CONTROL CABLE section.
Why does my CERTIFIED Snow Blower veer to one side?
If your CERTIFIED Snow Blower veers to one side, it might be caused by unequal tire pressure. In this case, adjust the tire pressure. Another possible cause is that the wheel spring lock pin is inserted on one side, so check the wheel locks. Unevenly mounted shoes or an uneven scraper blade could also be the reason; in such case, adjust the shoes or the scraper blade and shoes accordingly.
What to do if my CERTIFIED 060-3742-2 engine starts hard?
If the CERTIFIED Snow Blower engine starts hard or runs poorly, it could be due to spark plug issues, so replace the spark plug. Another cause might be that the fuel cap ventilation is blocked, so clear the ventilation.
Why my CERTIFIED 060-3742-2 does not drive?
If the CERTIFIED Snow Blower does not drive, the drive cable might be out of adjustment, so adjust it. See ADJUSTING SELF-DRIVE CONTROL HANDLE CABLE section. Another cause could be a worn or broken auger drive belt, so replace the traction drive belt. See REPLACE AUGER DRIVE BELT section. Finally, the friction disc might be worn out, so repair or replace it. See REPAIR OR REPLACE FRICTION DISC section.
General| Engine Displacement | 208 cc |
|---|---|
| Drive Type | Self-Propelled |
| Engine Type | 4-Cycle |
| Clearing Width | 24 inches |
| Start Type | Recoil |
| Number of Speeds | 6 |
| Product Type | Two-stage |
| Intake Height | 21 inches |
| Throw Distance | 40 feet |
| Starter Type | Recoil |
To Next Page
