Need help?Do you have a question about the Certikin Genie MB20S and is the answer not in the manual?
Key technical details and dimensions for heater models.
Metrics like heat input, efficiency, and gas rates.
Essential safety warnings, pre-operation checks, and system requirements.
Function of On/Off switch, Lock/Reset button, and temperature display.
Meaning of LEDs and error messages shown on the heater.
Warnings regarding improper use and user competency requirements.
Required pool chemical levels and water quality for optimal heater performance.
Recommended periodic cleaning and heater service interval.
Legal requirements and industry standards for gas appliance installation.
Guidelines for selecting a suitable location and necessary clearances for the heater.
Gas supply pipework requirements and pressure for natural gas and propane.
Instructions for converting the heater from Natural Gas to LPG.
Requirements for flue systems, including plume management and flue length.
Air supply needs for the heater's installation space.
Minimum distances for flue terminal placement relative to openings and boundaries.
Details the condensate trap, drain outlet size, and pipework material recommendations.
Pool water plumbing, connection types, and pump recommendations for optimal heater life.
Wiring regulations, fuse rating, and disconnection methods for electrical supply.
General installation steps, space requirements, and siting considerations.
Outdoor terminals, other flue systems, and wall terminals.
Heater dimensions, connection points, and terminal dimensions.
Examples of flue setups and corresponding kit part codes.
Requirements for terminal guards and vertical roof terminal installations.
How to plumb the heater for pool water flow and pump requirements.
Instructions for connecting and routing the condensate drain pipe.
Electrical safety, wiring regulations, and connection methods.
Gas connection method, pressure requirements, and leak checking.
Instructions and diagrams for installing the wall mounting kit.
How to connect multiple heaters into a group cascade system.
Critical procedure for venting air from the primary circuit before operation.
Initial checks, temperature settings, and pressure switch adjustment.
Step-by-step guide for converting the heater from Natural Gas to LPG.
Process for checking and setting the burner, gas rate, and combustion.
Entering and using user setup mode to change display units and temperatures.
Safety controls, lockout conditions, and ignition sequence.
Accessing and using user and service modes for diagnostics and settings.
Fault codes displayed on the panel and corresponding LED indicators.
Detailed schematic of the heater's internal wiring for troubleshooting.
Steps for routine servicing, including cleaning and checks.
Instructions for replacing various heater components.
Heater components with part numbers for ordering spares.
Illustrations showing the location of major heater components.
Log for recording commissioning details and periodic service history.
To Next Page
General