Cessna 152 - Page 183

PILOT'S OPERATING HANDBOOK
SUPPLEMENT
WINTERIZATION KIT
MODEL 152
SUPPLEMENT
WINTERIZATION KIT
SECTION 1
GENERAL
The winterization kit consists of two cover plates to partially cover the
cowl nose cap opening, two placards to be installed on the cover plates,
insulation for the engine crankcase breather line, and a placard to be
installed on the map compartment door. This equipment should be
installed for operations in temperatures consistently below 20°F (-7°C).
Once installed, the crankcase breather insulation is approved for perman-
ent use, regardless of temperature.
SECTION 2
LIMITATIONS
The following information must be presented in the form of placards
when the airplane is equipped with a winterization kit.
1. On each cover plate:
REMOVE WHEN
OAT EXCEEDS 20°F
'2. On the map compartment door in the cabin:
1 July 1978
WINTERIZATION KIT MUST BE REMOVED
WHEN OUTSIDE AIR TEMPERATURE IS
ABOVE 20°F.
1 of2