Cessna 152 - Page 212

CESSNA 300 TRANSPONDER
AND ENCODING
ALTIMETER
PILOI''S OPERATING HANDBOOK
SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane limitations when this avionic equip-
ment is installed.
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
(1) Function Switch -- ON.
(2) Reply-Code Selector Knobs -- SELECT 7700 operating code.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
COMMUNICATIONS (WHEN IN A CONTROLLED ENVIRONMENT:
(1) Function Switch -- ON.
(2) Reply-Code Selector Knobs -- SELECT 7700 operating code
for 1 minute; then SELECT 7600 operating code for 15 minutes and
then
REPEAT this procedure at same intervals for remainder of
flight.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKEOFF:
(1) Function Switch -- SBY.
TO TRANSMIT MODE A (AIRCRAFT IDENTIFICATION) CODES IN
FLlGHT:
(1) Reply-Code Selector Knobs -- SELECT assigned code.
4
1
July 1978