CESSNA AIRCRAFT
COMPANY
SINGLE ENGINE
STRUCTURAL REPA
IR MANUAL
ENGINE COWLING REPAIRS
1. General
A. This section provides repair procedures for the cowl skins and reinforcement angles.
2. Repair of Cowl
ing Skins
A. Cowl halves are made of formed aluminum skin. If extensively damaged, complete sections of cowling
must be replaced. Standard insert-type skin patches, however, may be used if repair parts are formed
to fit. Small cr
acks may be stop drilled and dents straightened if they are reinforced on the inner side
with a doubler of the same material.
3. Repair of Rein
forcement Angles
A. Due to their small size, cowl reinforcement angles should be replaced (rather than repaired) if they
become damaged.
71-10-00 Page 801
© Cessna Aircraft Company Jun 1/2005
To Next Page
Loading...
