168
MAINTENANCE
Brake pad inspection
Inspect the front and rear brake pads and discs for damage and
wear. If the pad thickness
A
is less than 0.059 in. (1.5mm) or
the disc thickness
B
is less than 0.118 in. (3.0mm), have your
dealer replace them. Replacement of brake components requires
professional knowledge. These procedures should be performed
by your dealer.
NOTE:
Wheels must be removed to check brake pads.
CAUTION
After servicing:
• Make sure the brakes operate smoothly and that the lever
free play is correct.
• Make sure the brakes do not drag and the brake operation
is not spongy.
• All air is bled from the brake system.
A
B
To Next Page