CF MOTO ZFORCE 800EX - Page 80

76
CONTROLS AND FEATURES
On-Command 2WD / 4WD / 4WD-LOCK Switch Operation
To change from 2WD to 4WD: Stop the vehicle. Verify the mode lever is moved to the left, and then press the
switch to “4WD”. The 4WD indicator “ ” will display in the dashboard.
To change from 4WD to 2WD: Stop the vehicle. Verify the mode lever is moved to the left, and then depress
the switch to “2WD”. The 2WD indicator “ ” will display in the dashboard.
To change to 4WD-LOCK: Stop the vehicle. To lock the front di󰀨erential while in 4WD mode, verify the mode
lever is moved to the right, and then depress the switch to “LOCK”. The 4WD-LOCK indicator “ x ” will display
in the dashboard.
NOTE:
4WD-LOCK OPERATION:
• Steering will require greater e󰀨ort in 4WD-LOCK mode. This is normal.
• When the switch is set to “LOCK”, the front di󰀨-lock indicator light will ash until the front di󰀨 is locked.
• If the indicator light is flashing, turning the steering left and right will help the front gear locking
mechanism to engage.
• Riding before the front differential lock is properly engaged (e.g., the indicator light is flashing) will
cause the engine speed to be limited until engagement is complete.
• When the vehicle is in 4WD-LOCK, the maximum traveling speed is limited to 22 mph (35 km/h).
• If conditions require full engine power to be available, press the override switch on the dashboard to
disable the 4WD-LOCK speed limiter.