OPERATION
ON COMMAND DIFFERENTIAL GEAR LOCK SWITCH "4WD"/'LOCK"
To lock the differential gear in 4WD, stop the vehicle, make sure the On‐Command four wheel-drive
switch is set to "4WD", move the differential gear lock lever to position (b), and then set the switch
to "LOCK”∙.When the differential gear is locked, the differential gear lock indicator light
("DIFF. LOCK') will come on along with the differential gear lock indicator in the multi-function
display.
To release the differential gear lock, stop the
vehicle and set the switch to "4WD".
When the switch is set to "LOCK”, the
differential gear lock indicator and
indicator light will flash until the
differential gear is locked.
When the indicator and indicator light are
flashing, turning the steering wheel back
and forth will help the differential gear
lock to engage.
Driving before the differential gear lock is properly engaged (e.g., when the indicator and indicator
light are flashing) will cause the engine speed to be limited until engagement is complete.
-75-
To Next Page
Loading...