CFMoto 650NK - Page 35

2-16 PERIODIC MAINTENANCE
If necessary,adjust the throttle cable as follows.
 Loosen the locknut [A] at the upper end of the
accelerate cable.
 Turn the adjuster [B] in completely so as to give
the throttle grip plenty of play.
 Loosen the locknut [A] at the middle of the
decelerate cable.
 Turn the adjuster [B] until there is no play when
the throttle grip is completely closed.
 Tighten the locknut.
 Turn the accelerate cable adjuster until the proper
amount of throttle grip free play is obtained.
 Tighten the locknut.
Idle Speed Inspection
 Start the engine and warm it up thoroughly.
With the engine idling, turn the handlebar to both
sides [A].
If handlebar movement changes the idle speed,
the throttle cables may be improperly adjusted or
incorrectly routed or damaged. Be sure to correct
any of these conditions before diding.
WARNING
Operation with improperly adjusted,incorrect-
ly routed or damaged cables could result in
an unsafe riding condition.
 Check the idle speed.
If the idle speed is out of the specified range,
check throttle body for air leaks and calibration.
Idle Speed
Standard: 1300 130 r/min(rpm)
!