-100-
Changing the coolant
1. Place the ATV on a level surface.
2.Place a container under the engine, and then remove the coolant drain bolt .(Use a trough or
a similar object to prevent coolant from spilling on the footrest.)
3.Remove the radiator cap.
4.Remove the coolant reservoir cap.
DANGER
After stop the engine, you cannot remove cap of radiator immediately. Wait for
a while to cool down the coolant and then remove radiator cap. Otherwise hot
coolant will goes out to hurt people nearby.
5.
Disconnect the hose on the coolant reservoir side, and then drain the coolant
from the coolant reservoir.
6.After draining the coolant, thoroughly flush the cooling system with clean tap
water.
7.Replace the coolant drain bolt washer if it is damaged, and then tighten the coolant drain bolt to the
specified torque.
Maintenance & Lubrication
1
1
To Next Page
Loading...