-101-
Coolant drain bolt tightening torque：10 N·m
NOTE
8.Install the coolant reservoir hose.
9.Fill the recommended coolant into the radiator until it is full.
When filling coolant, at the same time to loosen tapping screw
as right picture shows in order to drain potential air bubbles
inside the coolant hose, until coolant goes out, then tighten the
screw .
NOTE
Recommended antifreeze:
High quality ethylene glycol antifreeze containing corrosion inhibitors
for aluminum engines. Antifreeze and water mixing ratio:1:1
Coolant capacity: 3.0 L
Coolant change：2.9 L
Coolant reservoir capacity：0.38~0.6L
Maintenance & Lubrication
CAUTION
Hard water or salt water is harmful to the engine.
Please use CFMOTO recommended coolant.
1
1
To Next Page