Engine can be started in any gear if rear brake pedal is applied. However it is recommended to shift
into neutral or park before starting the engine.
Completey close throttle lever and start the engine by pushing the start switch.
If the engine fails to start,release the start switch,then push the start switch again. Pause a few
seconds before the next attempt.
Ea
ch cranking should be as short as possible to preserve battery
energy. Do not crank the engine more than 10 seconds on each at tempt.
If the battery is discharged,disassemble the battery to recharge.
Continue warming up the engine until it idles smoothly before starting the ATV.
CAUTION
See the“Break-In Period”section prior to operating the engine for the first time.
-71-
Operation
NOTE
When the gear selector is in neutral position,if indicator light on dashboard does not come on,ask
your dealer to inspect its electric circuit or adjust gear-shifting system.
To Next Page
Loading...