-97-
Rear gear case oil
The rear gear case must be checked for oil leakage before each
ride . If any leakage is found,have your dealer check and repair
the ATV.
Rear gear oil change
1. Place the machine on a level place.
2. Place a container under the rear gear case to collect the used oil.
3. Remove oil drain bolt as right picture shows and drain used oil.
4. Add recommended gear oil into rear gear case.
5. Install and tighten drain bolt as specified torque after adding new gear oil.
NOTE
Tightening torque of drain bolt: 23N
.
m
Periodic oil change：0.40 L
Maintenance & Lubrication
1
1
1
6. Check if any oil leakage. In case of leakage, please find
:
Be sure
QRforeign material enters the rear gear case.
NOTE
causes and remove it
To Next Page
Loading...