82
NOTE
Remove the thermostat cover screw before
filling the coolant. This would help to bleed
the air trapped in cooling system. Install the
thermostat screw when coolant spills.
NOTE
Always use ethylene-glycol antifreeze contain-
ing corrosion inhibitors specifically for internal
combustion aluminum engines.
We recommend the use of a 50/50 mixture of
anti-freeze and distilled water.
Always use CFMOTO premixed coolant.
Coolant capacity in total: 2.9 L
Coolant capacity at replacement: 2.8 L
To change the coolant in reservoir
Coolant reservoir capacity: 0.3 L
CAUTION
Tap water or sea water is harmful for the en-
gine. Always use recommended coolant.
9. Install the radiator pressure cap.
10. Start the engine and allow it to idle for a
few minutes, and then stop the engine.
Check the coolant level in radiator after the
cooling system is fully cooled down. If cool-
ant level is below the lower mark, add rec-
ommended coolant to radiator filler neck.
11. Add coolant in reservoir to the upper mark.
12. Install the coolant reservoir cap and check
for coolant leaks.
13. Install the removable hood.
To Next Page
Loading...