EasyManua.ls Logo

CG Antenna CG-3000 User Manual

CG Antenna CG-3000
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
CG-3000 AUTOMATIC ANTENNA TUNER
INTRODUCTION
CG-3000 automatic antenna tuner (ATU) can cover whole HF amateur
bands. It uses multi signal processing circuit to switch L/C to make perfect
matching between your radio and antenna system. Fast tuning, less than 2
seconds for first initialize matching. 200 memory channels store the
minimum SWR value to make further tuning.
SPECIFICATION
Working frequency: 1.6-30 MHz (50 MHz not guaranteed)
Input impendence: 50 ohm
Max. input power: 200W PEP
Min. inp ut power: 10W
Power supply: 13.8V +/- 10%
Current drain: < 0.8 A
Auto tuning time: Approx. 2 sec. (first time tuning)
< 0.2 sec (return to memorized frequency)
Memory channels: 200
Usable wire length: 6 – 30 Mhz > 2.4 meters
1.6 – 30 Mhz > 8 meters
* All specifications are subject to change without notice or obligation
Question and Answer IconNeed help?

Do you have a question about the CG Antenna CG-3000 and is the answer not in the manual?

CG Antenna CG-3000 Specifications

General IconGeneral
BrandCG Antenna
ModelCG-3000
CategoryTuner
LanguageEnglish

Summary

Introduction to CG-3000 Automatic Antenna Tuner

CG-3000 Specifications

Using the CG-3000

Installation Guide

Steps to connect antenna, ground, transceiver, control cable, and mount the unit for operation.

Operation Procedures

Ground System and Setup Considerations

Important Setup Attention Points

Key points: verify power, ensure antenna length, avoid BALUN, shorten coax.

Product Warranty Information

Repair Service and Procedures

Related product manuals