Need help?Do you have a question about the CGOLDENWALL ST-135 and is the answer not in the manual?
General| Brand | CGOLDENWALL |
|---|---|
| Model | ST-135 |
| Category | Iron |
| Language | English |
Connect to cold water supply, includes shut-off valve and strainer.
Use copper pipe, max 3 meters, pitch towards steam head, requires 1.5" hole.
DN15 pipe for draining, unit drains by gravity, auto drain turns on after 15 mins.
Install in shower room, point to floor, height 30cm from ground or 20cm from bathtub edge.
Illustrates connections for 110V and 220V systems, showing live, neutral, and ground wires.
Verify earth connection, model suitability, voltage, and vertical installation.
Ensure correct voltage, proper cable/breaker, and avoid adding wires.
Install inside/outside shower room, sealed with silicone adhesive, cable length 32 feet.
Install indoor/outdoor, drill hole, connect control lines, use adhesive/sealant.
Install at 1.5m height, exposed to air, drill 1/4" hole, route cable through wall.
Machine must be grounded, install in dry/ventilated place, use glass glue for fixing.
Explains display, indicator lights, start/stop, and temperature setting functions.
Procedures for changing heater, circuit board, solenoid valve, and water level probe.
Issue caused by disconnected/damaged temperature probe; check connections.
Check water supply, wiring, controller, and circuit board for potential causes.
Interprets red, green, yellow, and orange lights for troubleshooting.
Check controller wiring and circuit board for damage or dampness.
To Next Page