CHAD EVOLUTION - Component Descriptions; Continuous Flow Caution; Bodok Seal Warning

 3V^)H[[LY`0UKPJH[PVU! The EVOLUTION™ conserver incorporates visual and audible warnings which indicate when a battery
change is needed.
)SPURPUNYLKSPNO[ - Low battery energy level. Replace batteries.
  (\KPISLHSHYT - Low battery energy level. Replace batteries.
 (WULH0UKPJH[PVU! The EVOLUTION™ conserver incorporates visual and audible warnings which indicate when a breath is not
detected for a period of time.
)SPURPUNYLKSPNO[ – No breath has been detected for 30 seconds, +/- 5 seconds.
(\KPISLHSHYT – No breath has been detected for 30 seconds, +/- 5 seconds.
 =HS]L(KQ\Z[TLU[2UVI! This is used to attach the unit to any medical oxygen Pin Index valve cylinder.
 7V^LY)\[[VU! Switches the conserver ON and OFF.

-SV^:LSLJ[VY2UVI!  
It also enables the user to select the continuous flow mode setting. The continuous flow mode setting (CF) is designed for
emergency use only. The amount of medical oxygen delivered when using the EVOLUTION
TM
in continuous flow mode is preset
at 2 LPM (liters per minute). When not in use, the cylinder should be turned off by turning the valve clockwise and the conserver
 
+,:*907;0656-7(9;:*65;963:

The CF mode (continuous flow) is a mechanical override designed as a safety feature in case battery power fails. It is set at 2
 
no effect on medical oxygen output.
*(<;065 In the event that it is necessary to operate the unit in the continuous flow mode, DO NOT obstruct the flow of medical
oxygen from the Medical Oxygen Supply Outlet by placing your finger over the outlet or blocking the flow through the oxygen tubing
in any way. Doing so may render the unit inoperable and/or damage the sensor in the unit.
 56;,!9LTLTILY[OH[PUJVU[PU\V\ZMSV^TVKL[OLTLKPJHSV_`NLU^PSSILJVUZ\TLKH[HT\JOMHZ[LYYH[L
 9L[\YU[VHUV[OLYZV\YJLILMVYLKLWSL[PUN[OLTLKPJHSV_`NLUJ`SPUKLY
 )H[[LY`*VTWHY[TLU[! 
 4LKPJHSV_`NLU7YLZZ\YL.H\NL! This enables the user to monitor the contents of the compressed medical oxygen cylinder.
 4LKPJHSV_`NLU:\WWS`6\[SL[! Use this fitting to attach a standard cannula.
 =HS]L(SPNUTLU[7PUZ! When assembling the unit, these parallel pins must go into the matching holes on the cylinder valve.
 )VKVR:LHS! This creates the sealing interface between the valve and the EVOLUTION
TM
conserver.
4LKPJHS6_`NLU0USL[*VUULJ[PVU! Interface between cylinder valve and conserver that allows medical oxygen to flow into the
regulator.
 >(9505.Use only a . Other seal washers may not be medical oxygen
 