• Unscrew the 3 screws from the template (Picture 1).
• Fix the two parts of the base together (Picture 2). Pass the power cord through the
center hole of the base.
• Align the base and template, and fix the 3 screws using a screwdriver (Picture 3).
• Insert the wire until it reaches the opening at the bottom of the base (Picture 4).
4.OPERATION.
Set the appliance on a dry, level and sturdy surface.
Plug the appliance into the mains.
Note: All controls can be operated from the fan unit or from the remote control.
To Next Page
Loading...
