Challenger Mobility J2840 User Manual (English)

To Next Page

J2840 Pet Carrier Trailer

Assembly Instructions

No tools needed!

Adjustable wrench optional, but not required.

Parts Included:

(2) – Inflatable Tires/Wheel Assembly 57-305 (16x2.125)

(1) – Frame Assembly Pieces w/ Attached Enclosure

(1) – Safety Flag

(1) – Hitch Attachment

(1) – Ball Hitch Adapter

1. Remove all parts from box, unwrap and check inventory per the above list.

2. Pet trailer comes in a folded condition. Unfold the two sides, reach inside and raise the crossbar

into the locking slot. Insert the locking pin. Trailer is now fully unfolded.

3. Flip the trailer onto one side. Remove the rubber cap from the wheel axle. The rubber cap can

be discarded or saved if you plan on disassembling the trailer at a later time.

1 of 5

Need help?

Do you have a question about the Challenger Mobility J2840 and is the answer not in the manual?

Challenger Mobility J2840 Specifications

General

Unfold the trailer, secure its frame, and remove protective caps from wheel axles.

Attach wheel assemblies to the trailer and inflate tires, adhering to pressure limits.

Connect hitch adapter and receiver, secure ball hitch, and adjust towing height.

Assemble and insert the safety flag into the trailer's designated slot for increased visibility.

Confirm the trailer is fully assembled, attached to the scooter, and ready for use.