Challenger AP10LED

AP10LED Manager Guide
1
Manager Guide
This User Guide tells you how to operate your intruder alarm system. To simplify this User Guide
we have assumed that the alarm system has been installed by a professional intruder alarm system
installer (the installer), and that the system is operated in a “typical” way. Aspects of your system
that are not “typical” will be described by your installer.
NOTE: If you have any questions about your intruder alarm system, then consult your installer,
see contact details at the front of this User Guide.
Indications on the system
Indications
LED steady on indication
LED flashing indication
LED off
Internal Sound
External Device: Strobe
External Siren: Bell
Using System
After you had finish system settings, you can use the system now. This section gives an operation
of how to set and unset the system as well as how to reset after an alarm.

Challenger AP10LED Specifications

General

Light Source	LED
IP Rating	IP44
Power	10W
Luminous Flux	800 Lumens
Detection Range	10m
Frequency	50Hz
Material	Plastic

Summary

Indications on the system

How to Set the System

How to OMIT a zone(s)

Unsetting the System

How to UNSET from Alarm and RESET the system

How to Set up the system

Setup Codes

How to change Managers Code

How to change User Code

View Event Log

Test System

How to Test Outputs

Guide to testing bell, strobe, and speaker outputs of the alarm system.

How to enter Walk Test