Connect to your controller via your
STA ip address and the home
screen will load. From the menu
button select WEB access
settings.
MQTT REMOTE CONNECTION
Prior to starting you NEED to ensure that you have the STA ip address of the
controller and that your device / connection has access to the internet.
Ensure your screen
replicates what is shown
here (Your security key will
be different to that shown).
Ensure local browser
settings are as shown
and that YOUR local
security key is the same
as YOUR MQTT security
key. You will need to add
it
Now browse to www.aclsretail.com and
nd the link to Challenger WiFi
Controller portal as shown (or use
Scan Me). Once open, from menu
select MQTT settings.
Check broker and port
number is as above in stage
2 picture. Username &
password not required.
Enter your Local security
key here and press enter.
On pressing enter, you should remotely connect to your controller, if not ensure that you
have correctly entered the information as shown. It is advised to save this page to your
device home screen, thus next time you simply need to select the saved icon
Changes only
required in this
section
This cannot be
changed
Do not try to
change anything in
this section, it will
self populate on
connection
MAKE ALL
SAME
DIESEL AUTOHEAT
1
3
4
2
Ensure source is set to MQTT
Actual controller screen
As seen in system
settings on controller, if
STA is not there you
need to follow steps as
listed overleaf.
X
To Previous Page
Loading...
Need help?
General