NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)this device
must accept any interference received, including interference that may cause undesired operation.
REPLACE THE BATTERY
The LED on your remote will stop flashing when the battery is low and needs
to be replaced. To replace battery, open the case as shown. Insert battery
positive side up (+). Replace the battery with only 3V CR2032 coin cell
batteries. Dispose of old battery properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or
incinerate.
REPLACEMENT PARTS
1
2
3
WARRANTY
ONE YEAR LIMITED WARRANTY
The Chamberlain Group LLC warrants to the first consumer purchaser of this
product that it is free from defect in materials and/or workmanship for a
period of 1 year from the date of purchase.
Pry open the case with a
screwdriver blade.
956EV, 956EV-P2, 956EVC AND
956EVC-P2
Remote Control Transmitter 953EV: IFT #: RCPCH9518-0362
Remote Control Transmitter 953EVC: IFT #: RCPCH9518-0362-A1
Remote Control Transmitter 956EV: IFT #: RCPCH9518-0360
Remote Control Transmitter 956EVC: IFT #: RCPCH9518-0360-A1
4
Press and release the Learn
button on the garage door
opener.
3
To exit programming mode,
press any remote control
button except the button
that was just programmed.
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
1
Within 30 seconds...
The Learn LED will light.
5
Press and hold the program button
the remote control until the LED on
the front of the remote control
turns on.
Safety pin or
paper clip
Learn
Button
Click
Click
2
Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses Garage Door Opener Type
1
2
3
4
Yellow Learn Button (Security+ 2.0
®
)
Purple Learn Button (315 MHz Security+
®
)
Red/Orange Learn Button (390 MHz Security+
®
)
Green Learn Button (390 MHz Billion Code)
To test, press the programmed button on the remote control...
6
The garage door opener
will activate.
PROGRAM THE REMOTE CONTROL (956EV, 956EV-P2,
956EVC AND 956EVC-P2)
Pry open the case first in the
middle (1), then at each side (2
and 3) with the visor clip.
953EV, 953EV-P2, 953EVC AND
953EVC-P2
PROGRAM THE REMOTE CONTROL (953EV, 953EV-P2,
953EVC AND 953EVC-P2)
4
Press and release the Learn
button on the garage door
opener.
3
To exit programming mode,
press any remote control
button except the button
that was just programmed.
Install the visor clip.
7
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
To test, press the programmed
button on the remote control...
1
Within 30 seconds...
The Learn LED will light.
56
Press and hold the program button
the remote control until the LED on
the front of the remote control
turns on.
Learn
Button
Click
Click
The garage door
opener will activate.
2
Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses Garage Door Opener Type
1
2
3
4
Yellow Learn Button (Security+ 2.0
®
)
Purple Learn Button (315 MHz Security+
®
)
Red/Orange Learn Button (390 MHz Security+
®
)
Green Learn Button (390 MHz Billion Code)
Battery ...................................................10A20
Visor Clip ................................................29B137
(Models 953EV, 953EV-P2, 953EVC & 953EVC-P2 ONLY)
To Next Page
Loading...
Need help?
General
