How to fix Champion Power Equipment Log Splitter when engine will not start?
If your Champion Power Equipment Log Splitter engine won't start, make sure it has fuel by adding fuel to the tank. Also, check the spark plug and replace it if it's faulty. Ensure that the unit isn't loaded during start up; remove any load from the unit.
What to do if Champion Power Equipment 100425 Log Splitter engine will not start; Engine starts but runs roughly?
If your Champion Power Equipment Log Splitter engine won't start or runs roughly, check the oil level and fill the crankcase to the proper level. Make sure the log splitter is on a flat, level surface. Adjust the choke, and ensure the spark plug wire is securely attached to the spark plug.
What to do if Champion Power Equipment 100425 Log Splitter engine shuts down during operation?
If your Champion Power Equipment Log Splitter engine shuts down during operation, first, check the fuel level and fill the fuel tank if it's out of fuel. Also, check the oil level and fill the crankcase to the proper level. Ensure the log splitter is placed on a flat, level surface.
Why is wedge movement slow or erratic on Champion Power Equipment 100425 Log Splitter?
If the wedge movement is slow or erratic on your Champion Power Equipment Log Splitter, it might be due to air in the hydraulic oil system. Purge the air by extending and retracting the wedge several times until the motion is smooth. Also, check for debris lodged in the beam guides and clear any debris from the beam. Finally, verify the hydraulic oil level and add more if needed.
How to stop excessive bouncing while towing Champion Power Equipment 100425 Log Splitter?
To resolve excessive bouncing while towing your Champion Power Equipment Log Splitter, inflate the tires to the proper pressure, referring to the tire sidewall for the correct pressure.
What causes oil leak from cylinder in Champion Power Equipment Log Splitter?
If there is an oil leak from the cylinder of your Champion Power Equipment Log Splitter, tighten the hydraulic fitting. For issues such as a faulty cylinder rod seal, scored or bent cylinder rod, or a faulty combination washer seal on the cylinder hydraulic fitting, contact Customer Service.
What to do if wedge will not extend or retract on Champion Power Equipment Log Splitter?
If the wedge on your Champion Power Equipment Log Splitter will not extend or retract, check the hydraulic oil level and add as needed. For a faulty control valve or hydraulic pump, contact Customer Service.
Covers fire, carbon monoxide, hot surfaces, crush, projectile, and work zone hazards.
Addresses support leg pin, skin injection, towing, starter cord, and hot parts.
Details towing hazards, starter cord retraction risks, and hydraulic part heat.
Details dangers of gasoline and proper fueling procedures.
Step-by-step procedures for starting and stopping the engine.
Instructions for unpacking the log splitter.
Steps to attach the tow bar to the splitter.
Steps to mount the wheels onto the axle.
Steps to attach the beam to the frame.
Steps to mount the engine onto the platform.
Instructions for connecting hydraulic hoses.
Detailed steps for starting the engine, including choke usage.
How to operate the log splitter safely and effectively.
Identifies common problems and provides solutions.
General| Engine Displacement | 224cc |
|---|---|
| Splitting Force | 25 Tons |
| Max Log Length | 24 inches |
| Orientation | Horizontal |
| Fuel Tank Capacity | 0.9 gallons |
| Warranty | 2-Year Limited |
| Engine | Champion 224cc OHV |
| Oil Capacity | 0.63 Quarts |
| Dimensions (L x W x H) | 85.8 x 42.1 x 39.2 inches |
To Next Page