Champion Power Equipment 100472 User Manual

OPERATOR'S MANUAL
MODEL #100472
3 IN. (7.6 CM) CHIPPER SHREDDER
Made in China - REV 20200507 Champion Power Equipment, Inc., Santa Fe Springs, CA USA
or visit championpowerequipment.com
READ AND SAVE THIS MANUAL. This manual contains important safety precautions which should be read and understood before operating the product. Failure to
do so could result in serious injury. This manual should remain with the product.
Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice.
REGISTER YOUR PRODUCT ONLINE
at championpowerequipment.com

Champion Power Equipment 100472 Specifications

General

Brand	Champion Power Equipment
Model	100472
Category	Paper Shredder
Language	English

Summary

Important Safety Instructions

Hazard Warnings (Carbon Monoxide, Fire, Rotating Parts)

Covers critical hazards like carbon monoxide, fire risks, and entanglement with rotating parts.

Operational Safety Precautions (Fuel, Work Area, Clothing)

Details safe operation practices including fuel handling, work zone, and required safety gear.

Operational Hazards and Restrictions (Kickback, Clogging, Size Limits)

Addresses risks like starter cord kickback, material clogging, and size limitations for safe operation.

Safety Labels and Symbols

Controls and Features Overview

Component Identification

Assembly Instructions

Unit Unpacking and Wheel Installation

Chute, Hopper, and Handle Assembly

Fueling and Oil Filling Procedures

Instructions for adding engine oil and fuel, including break-in period advice.

Operation Guidelines

Safe Operation Location and Work Area

Specifies requirements for operating location, work area, and safety zones.

Pre-Operation Checks and Engine Starting

Outlines essential inspections before use and the procedure for starting the engine.

Chipping, Shredding, and Clearing Procedures

Maintenance Procedures

General Maintenance Safety and High Altitude

Emphasizes safety during maintenance and discusses high altitude operation.

Engine Maintenance (Oil, Spark Plug, Air Filter)

Detailed steps for changing engine oil, cleaning spark plugs, and maintaining the air filter.

Blade Inspection, Sharpening, and Replacement

Procedures for inspecting, sharpening, and replacing chipper and shredder blades.

Maintenance Schedule and Storage

Scheduled Maintenance Intervals

Unit and Engine Storage Procedures

Troubleshooting Guide

Engine Start and Performance Issues

Operational and Noise Issues

Warranty Information