EasyManua.ls Logo

Champion 100683 - User Manual

Champion 100683
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATOR'S MANUAL
MODEL #100683
CURVED SHAFT TRIMMER
Made in China - REV 20200622 Champion Power Equipment, Inc., Santa Fe Springs, CA USA
or visit championpowerequipment.com
SAVE THESE INSTRUCTIONS. This manual contains important safety precautions which should be read and understood before operating the product. Failure
to do so could result in serious injury. This manual should remain with the product.
Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice.
WARNING
To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. If you do not
understand the warnings and instructions in the operator’s manual, do not use this product.
NOTICE
Do not use E15 or E85 fuel (fuel containing ethanol greater than 10%) in this product. It is a violation of federal law and will
damage the engine and void your warranty. FUEL MIXTURE for this product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil in a 50:1 ratio. Pre-mix unleaded gasoline and 2-cycle engine oil in a clean container approved
for gasoline. DO NOT mix quantities larger than usable in a 30-day period.
REGISTER YOUR PRODUCT ONLINE
at championpowerequipment.com

Questions and Answers

Summary

Introduction

Safety Definitions

Explains DANGER, WARNING, CAUTION, NOTICE symbols for hazard communication.

Important Safety Instructions

Fuel Safety

Precautions for handling flammable fuel to prevent serious personal injury.

Safety Labels

Explains the meaning of warning labels on the equipment for hazard identification.

Safety Symbols

Explains various symbols used on the product and their meanings for safe operation.

Controls and Features

Parts Included

Assembly

Operation

Fueling and Refueling

Instructions on mixing fuel and filling the fuel tank safely.

Starting and Stopping Engine

Procedures for starting a cold/warm engine and safely stopping the trimmer.

Trimmer Operation and Line Extension

Guidelines for proper cutting techniques and extending trimmer line.

Replacing Trimmer Line

Maintenance

General Maintenance and Cleaning

Basic cleaning procedures and upkeep for the trimmer.

Engine Parts Diagram

Engine Parts List

Troubleshooting

Warranty

Emission Control System Warranty

Summary

Introduction

Safety Definitions

Explains DANGER, WARNING, CAUTION, NOTICE symbols for hazard communication.

Important Safety Instructions

Fuel Safety

Precautions for handling flammable fuel to prevent serious personal injury.

Safety Labels

Explains the meaning of warning labels on the equipment for hazard identification.

Safety Symbols

Explains various symbols used on the product and their meanings for safe operation.

Controls and Features

Parts Included

Assembly

Operation

Fueling and Refueling

Instructions on mixing fuel and filling the fuel tank safely.

Starting and Stopping Engine

Procedures for starting a cold/warm engine and safely stopping the trimmer.

Trimmer Operation and Line Extension

Guidelines for proper cutting techniques and extending trimmer line.

Replacing Trimmer Line

Maintenance

General Maintenance and Cleaning

Basic cleaning procedures and upkeep for the trimmer.

Engine Parts Diagram

Engine Parts List

Troubleshooting

Warranty

Emission Control System Warranty

Champion 100683 Specifications

General IconGeneral
Starting SystemRecoil
Cutting Width17 inches
Line Diameter0.095 inches
Cutting SystemBump Feed Head
Shaft TypeStraight shaft
Engine Type2-Cycle