Champlain ACM-125 - User Manual

ACM-125 / ACM-125C
Universal Pool Light
INSTALLATION ON A POOL STEP
1) Assemble step as per instructions.
KEEP STEPS AND LIGHT DRY DURING INSTALLATION.
2) Using a 2” (50.8mm) cutting devise, drill a hole in the second riser
from the top at 4-1/2” (114.3mm) from the top at center.
3) Thread the electrical cord through the hole (as per drawing).
4) Secure the light from behind with the plastic nut.
DO NOT OVERTIGHTEN.
5) Secure plastic nut with the safety cap and 2 supplied screws.
6) Attach the electrical cord to the step.
7) Make sure the transformer is out of the water. Slide plastic
O-ring onto transformer plug.
8) Insert pins into transformer outlet and secure with cap.
9) The transformer should be plugged into a GFCI outlet.
!
"
#
$
%
Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
(INS-ACM125-rev2)
• Risk of electrical shock, if instructions are not followed. Connect only to a
grounded GFCI outlet that is a minimum of 10 feet (3 m) away from the
pool. DO NOT USE EXTENSION CORDS.
• Make sure the electrical cord is properly attached to the step to avoid
entanglement.
• Do not let children use this device unsupervised.
• For use on permanent above-ground pools only.
• Do not use the light if the lens, transformer or cord is damaged.
WINTER STORAGE: Freezing weather may damage light fixture.
Disconnect light and remove from the pool. Store in dry space at room
temperature.
WARNING
and centered
on riser
4-1/2”
from top
of riser
&
'

Summary

Install Universal Pool Light on Pool Step

Drill Pool Step Mounting Hole

Drill a 2-inch hole in the second riser from the top at 4-1/2 inches from the top.

Secure Light Fixture to Step

Secure the light with the plastic nut, safety cap, and screws, avoiding overtightening.

Connect Transformer and Power

Connect the transformer to the light and plug into a GFCI outlet, ensuring it is out of water.

Pool Step Installation Safety

Follow electrical safety, GFCI requirements, and winter storage guidelines for pool step installation.

Install Universal Pool Light on Above-Ground Pool Wall

Drill Pool Wall Mounting Hole

Drill a 2-inch hole through the pool wall and liner for light installation.

Install Gasket and Secure Light

Insert gasket, thread cord, and secure light with plastic nut and safety cap, avoiding overtightening.

Connect Transformer and Power

Ensure transformer is dry, connect to light, and plug into a GFCI outlet.

Pool Wall Installation Safety

Adhere to electrical safety, GFCI requirements, and winter storage guidelines for pool wall installation.

Champlain ACM-125 Specifications

General

Lamp Type	LED
Light Source	LED
IP Rating	IP68
Lifespan	50, 000 hours
Voltage	12V
Color Temperature	3000K
Beam Angle	120 degrees