Model 9530034R04 LED Grill Light Instructions
• The LED Grill Light uses 3 AAA batteries. New batteries are recommended.
• Remove the cover and remove the battery carrier.
• Insert the batteries into the carrier, aligning the batteries with + and – marks.
• Insert the battery carrier, ensuring it is in proper alignment with the electrical
contacts.
• Close the battery cover.
• Test the light operation by pressing the switch on top of the light.
• If the light doesn’t work, remove, rotate and reinsert the carrier to ensure it
is in proper alignment with the electrical contacts. Close the battery cover
and retry the operation.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (Carbon-Zinc) or rechargeable (Nickel- Cad-
mium) batteries.
• Remove batteries when storing product for extended periods of time.
• Avoid contact with water as moisture can damage your LED Grill Light.
MOUNTING THE GRILL LIGHT:
1. Allow the grill to cool completely prior to mounting the grill light.
2. Raise the grill lid to the fully open position.
3. Disengage the exible red strap from the two engagement posts.
4. Position the light along the handle at a location where it will not interfere
with normal operation. And allows you to close the lid without hitting the
front of the grill.
5. Pull the red exible strap around the handle. Do not over tighten. When
the red exible strap is tight, reattach it to the two engagement posts.
Close the lid slowly to make sure it will not interfere.
6. Turn On or Turn Off the light by touching the on/off button on the top of
the light. Thick Gloves may hinder operation of the switch.
Refer to Illustration on last page.
80029787 • © 2019 Char-Broil,LLC
charbroil.eu
GB
To Next Page
Need help?
General