Need help?Do you have a question about the Charnwood W815 and is the answer not in the manual?
Instruction to attach the shorter locking handle to the tailstock barrel.
Instruction to attach the longer locking handle to the tool post assembly.
Instruction to place and secure the tool rest stem in the banjo.
Instruction to bolt the tool tray to the tailstock end of the lathe.
Procedure for adjusting the tension of the drive belt by repositioning the motor.
Steps for changing the drive belt, including releasing tension and removing covers.
Guide for replacing worn carbon brushes on the motor when down to 7mm.
To Next Page
General