Need help?Do you have a question about the Charnwood W813 and is the answer not in the manual?
General| Motor Power | 0.75 kW |
|---|---|
| Voltage | 230V |
| Spindle Speed | 500-2000 RPM |
| Spindle Taper | MT3 |
| Tailstock Taper | MT2 |
| Spindle Speed Range | 500-2000 RPM |
Read the manual, learn application, limitations, and potential hazards.
Confirm all tools are properly earthed for safe operation.
Ensure guards are in place and functional; replace if removed.
Habitually check and remove keys/spanners before switching on.
Maintain a clean workspace to reduce accident chances.
Avoid damp/wet locations, ensure good illumination.
Keep children at a safe distance from the work area.
Use padlocks, master switches, remove starter keys for child safety.
Operate within design limits for better performance and safety.
Use correct tools; contact manufacturer for suitability questions.
Avoid loose clothing, wear non-slip footwear, and secure hair.
Always wear safety glasses; normal spectacles are insufficient.
Maintain proper footing and balance, avoid over-reaching.
Keep machine clean and lubricated for best performance.
Ensure chuck keys and tools are removed before starting the lathe.
Stand to the side when starting to avoid flying debris.
Hand-rotate wood to check clearance and balance before starting.
Verify rotation speed before powering on to prevent high-speed starts.
Adjust speed based on timber size, balance, and condition for safe turning.
Keep tools on the tool rest when in contact with rotating wood.
Remove tool rest before sanding/polishing to prevent finger entrapment.
Avoid wrapping sandpaper around work to prevent finger pull-in.
Detailed technical specifications of the lathe model W813.
Description of the 'Hobby' rating for DIY users and enthusiasts.
Guidance on how to safely unpack the lathe from its carton.
Instructions for assembling the floor stand for the lathe.
Steps to securely mount the lathe onto the assembled stand.
Procedures for powering the lathe on and off using the controls.
How to adjust the operational speed using the speed control lever.
Instructions for rotating the headstock for various turning tasks.
Guide on moving, positioning, and locking the tailstock.
Steps to ensure correct alignment between headstock and tailstock centres.
How to position and adjust the height of the toolrest.
A table of recommended turning speeds based on workpiece diameter.
Steps to replace the worn drive belt on the lathe.
Common faults and their possible causes and remedies.
Visual representation of all lathe components with numbering.
A detailed list of all lathe parts with their corresponding numbers.
To Next Page
