Need help?Do you have a question about the CHART MVE 1879P-190 and is the answer not in the manual?
Explains symbols used in the manual for safety and warnings.
Details hazards and precautions for handling liquid nitrogen.
Lists essential protective gear for working with cryogenic materials.
Provides immediate care instructions for cryogenic exposure and asphyxia.
Specifies the application and purpose of the cryogenic freezers.
Basic instructions for installing the freezer unit.
Step-by-step guide for the initial filling process.
Explains how LN2 level is measured using a differential pressure sensor.
Details the automated LN2 level control system and its parameters.
Explains how temperature is measured using Pt-1000 RTDs.
Lists and describes the 18 available audible/visual alarms.
Details how to remotely monitor alarm conditions via dry contacts.
Explains the multilevel security system and password management.
Overview of serial ports and networking options.
Describes the data logging feature and event codes.
Explains the Hot Gas Bypass feature for efficient filling.
How to access and adjust temperature-related settings.
How to adjust high and low temperature alarm thresholds.
How to adjust LN2 level settings and alarms.
Setting high/low level setpoints and alarms for auto fill.
Configuration of advanced operational settings.
Resetting the controller to factory default settings.
Instructions for updating the controller's firmware.
Managing user access levels and passwords.
Changing the global password for security access.
Setting up and managing multiple security password levels.
Procedures for calibrating temperature sensors.
Steps for single-point calibration of temperature sensors.
Steps for two-point calibration of temperature sensors.
Procedure to calibrate the LN2 level sensor.
Calibrating the TEC 3000's liquid level readings.
Procedures for calibrating the hot gas bypass sensor.
Using TEC Connect software for monitoring and control.
Configuring OFAF networking for multiple freezers.
Recommended schedule for routine maintenance tasks.
Procedure to verify the accuracy of the LN2 level measurement.
Ensuring sufficient LN2 supply pressure and flow.
Procedures for testing high and low level alarms.
Comprehensive list of available ASCII commands.
To Next Page
General