Chasing M2 PRO - Maintenance, Safety, and Support; Navigation and Operational Safety; Battery and Charging Precautions; Component Maintenance and Care

Maintenance and Precautions
This content is subject to change without prior notice.
you could have the latest user manual by the
https://www.chasing.com
Navigation Safety
1
Battery Protection
2
Other
1. Do not turn on the LED lights before entering the water to avoid damages.
2. Check if the Thrusters/propellers are getting stuck by seaweed or external matters, rinse the ROV with fresh
water and then dry and put it back in the packing box.
3. Remote control cannot be washed with water, please clean it with towel.
4. The pull ring at the end of the battery can only be used to remove the battery, not to lift the ROV, otherwise
it may damage the ROV.
5. Do not place heavy objects on drone or accessories to avoid possible damage.
6. People under the age of 16 should only use this drone under adult supervision.
7. When not in use, please do not expose the drone and accessories under sunlight. Store it in a cool place or
in a special box.
8. Chloride or other chemicals can erode Chasing M2 PRO. Do not use if the pool is under high chlorine level.
Support
1. Any questions about our products please contact by support@chasing-innovation.com or leave a message
on the Chasing Website (https://www.chasing.com) chatting window.
2. You can also join the OFFICAL CHASING OWNERS GROUP on Facebook for latest news, app update and
other shared stories with Chasing Products worldwide.
Open sea
navigation
Relatively clear
water quality, no
dense seaweed
No dense radio
or radar signals
Do not dive
more than
492 ft
492 ft
Charging Protection
3
·Only use the Chasing standard adapter.
·Red light means charging.
·Green light means fully charged.
a. Do not touch the propellers of the Thruster
b. Do not unlock the Thruster for more than 30 seconds in the air to avoid overheating
c . After using the ROV in the salt water, please put it in fresh water for about 1 hour and turn it on, let the
drone run for10 minutes to discharge the salt, and try out the water after cleaning with a towel.
Thruster/ Propeller
4
Connector Sockets /Tether Connectors
5
·Check the Connector socket and tether pre-dive, keep dry and clean.
Salt and moisture may cause corrosion of the connector. Be sure to wash the socket with fresh water if
the interface has water stains, and make the connectors dry after cleaning.
O-ring
6
· Check whether the O-ring on the tether connector/Battery socket/micro SD card socket pre-dive, and
make a replacement when it is missed or damaged.
· It is recommended to grease the o-ring at the interface seal for maintenance each time when the battery
cabin and micro SD card are removed and installed
Do not run out
of battery power
Charge when
power is less
than 25%
When not in use,
keep battery power
at 50% - 70%
Working
temperature
-10 °C ~ 45 °C
( -18°F-113°F)