Chasing M2 S - Page 5

EN
07 08
EN
Pay-off and take-up
1） Installation
Press the button on the
right side of the
straightener to open the
straightener cover.
Insert the buoyancy wire
plug into the groove
interface of the winder
and tighten the nut.
Put the buoyancy line into
the straightener and close
the lid.
2） Pay off
Press the button on the
right side of the
straightener to open the
straightener cover.
Remove the buoyancy
line from the
straightener.
Close the cover of the
straightener, Fix the
winder and start manual
pay-off.
Install the manual handle.
3） Take-up
Press the button on the
right side of the
straightener to open the
straightener cover.
Put the buoyancy line
into the straightener
and close the lid of the
straightener.
Install the manual handle
and start to take up the
wire manually.