Chauvet DJ Hurricane 700

Other manuals for Chauvet DJ Hurricane 700

Quick Reference Guide20 pages

Questions and Answers

K
Kenneth ColemanJul 28, 2025
Why is my Chauvet DJ Hurricane 700 Fog Machine not powering up?
- T
  Taylor EdwardsJul 28, 2025
  If your Chauvet DJ Fog Machine isn't powering up, there are several things to check: * First, ensure the power outlet is working by testing it with another device or trying a different outlet. * Next, inspect the power cord for any damage or looseness. * Also, a blown fuse could be the culprit, so replace it with a new one of the same type and rating. * If none of these steps work, there might be an internal problem, and the product may need to be sent for repair.
N
Natasha ElliottAug 4, 2025
How to fix no output from Chauvet DJ Hurricane 700 spitting fluid?
- E
  Eileen RobinsonAug 4, 2025
  If your Chauvet DJ Fog Machine has no output or is spitting fluid, it could be due to incorrect fluid. Clean the machine thoroughly with CHAUVET® FCQ and then refill it with CHAUVET® water-based fog fluid. If the issue persists, it could be a blocked pipe or a failing part, and you should contact Customer Service.
S
sampsontiffanyAug 12, 2025
What to do if Chauvet DJ Hurricane 700 stops pumping and makes a loud noise?
- Q
  qaustinAug 12, 2025
  If your Chauvet DJ Fog Machine stops pumping and is making a loud noise, it could be due to a couple of reasons. First, check the fluid level and refill if it's low or empty. Also, the pump protection system might be engaged. Release the manual fog button, and then press it again to reset the pump protection system.
A
Austin PerryAug 19, 2025
Why does the circuit breaker keep blowing on my Chauvet DJ Fog Machine?
- F
  Frank WyattAug 19, 2025
  If the circuit breaker or fuse keeps blowing when using your Chauvet DJ Fog Machine, it could be due to a couple of reasons. One possibility is an excessive load on the circuit. Ensure that the total load does not exceed 80% of the breaker or fuse's nominal current. Another reason could be a short circuit along the power lines. In this case, check the power lines and power cords for any issues.