CHC i80 Quicktour

i80 GNSS Receiver Quick Tour with FieldGenius (Internal UHF Base)
1
1.Prerequisites
Hardware: CHC i80 Base with internal radio
Kit, Controller Kit,UHF Bar Antenna (450-470
MHz), Lithium Battery, Extension Pole,
Tribrach with optical plummet, Auxiliary H.I.
Tool, H.I. Tape, Tribrach adaptor, Tripod, LT30
handheld
Software: FieldGenius8
2.Steps to set i80 working as base
in internal UHF mode with
FieldGenius
2.1 Base installation
Set up base on known point or unknown
point as shown in follow figure and screw bar
antenna on base receiver.
Note: The recommend firmware version of
i80 is 1.3.36 or higher. If not, please contact
local dealer or CHC Support for latest
firmware.
2.2 Base setting in FieldGenius
1. Power on the receiver
Long press the i80 power button until the
green and blue LED lights are on.
2. Click on [start] and then FieldGenius.
3. Click [New Project] to create a project or
Click [Open] to open one exist project.

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English