Need help?Do you have a question about the CHC i80 and is the answer not in the manual?
General| Ingress Protection | IP67 |
|---|---|
| RTK Positioning Accuracy | Horizontal: 8 mm + 1 ppm Vertical: 15 mm + 1 ppm |
| Static Positioning Accuracy | Horizontal: 2.5 mm + 0.5 ppm Vertical: 5 mm + 0.5 ppm |
| Data Format | RTCM 3.2, CMR, CMR+, NMEA-0183 |
| Tilt Sensor | Yes |
| Communication | Bluetooth, Wi-Fi, 4G, UHF radio |
| Operating Time (RTK) | Up to 10 hours |
| Operating Temperature | -40°C to +65°C |
| Frequency Range | 410MHz to 470MHz (UHF) |
| Weight | 0.75 kg (1.65 lb) |
| Signal Tracking | GPS L1/L2, GLONASS L1/L2, BeiDou B1/B2, Galileo E1/E5b |
Covers warnings, cautions, regulations, and safety practices for receiver use, including FCC compliance.
Covers connecting to office computers, controllers via Wi-Fi/Bluetooth, and USB drives.
Guides users through setting up different working modes for base and rover stations.
Provides recommendations for optimal placement and environmental considerations for base station setup.
Explains how to configure the receiver to transmit correction data via internal or external radio.
Details configuration steps via Hcconfig and LandStar 6 software for base stations.
Offers advice on proper setup and environmental considerations for rover station operation.
Guides users on configuring the rover station using LandStar 6 for radio or cellular corrections.
Covers methods for collecting survey points, including conventional and tilt sensor measurements.
Explains how to perform site calibration to transform WGS-84 to local grid coordinates.
To Next Page
