7. Configuring through a web browser
i80 GNSS Receiver User Guide Page 82
b) Auto Base: The receiver will serve as a base after this mode is
enabled, and then broadcast correction data based on coordinate
inputted by user, or obtained through autonomous positioning
automatically.
c) Manual Base: The receiver will serve neither as a base or a rover
after this mode is enabled. Users need to configure the receiver
manually.
For Reference Latitude and Reference Longitude:
There are mainly three methods to enter the reference coordinates and
shown as follows:
a) Acquire Current Position: Click this button to acquire current
position obtained through autonomous positioning automatically.
b) Manual Input: Manually input the coordinate of a control point.
c) From CORS: After the receiver logging in CORS, the software can
record the coordinate of current position based on fix solution.
For Sample for Average:
Users can determine the positioning limit and sampling amount. The
positioning limit falls into two types:
a) Single Solution Coordinates: Collect the coordinates of receiver
obtained through autonomous positioning.
b) Fixed Solution Coordinates: Only collect coordinates of receiver
with a fixed solution.
After the configuration of positioning limit and sampling amount, click
to carry out sampling and averaging → the progress bar will
show the progress → the result will be served as the coordinate of
current positon.
If users need to save the changes, please tap button.
7.3.4. RECEIVER RESET SUBMENU
Use this screen to completely or partially reset the receiver:
To Next Page
Loading...
