CHC i80 User Manual

6. Survey with LandStar 6 software
i80 GNSS Receiver User Guide  Page 58
9. When the range pole is within the tilt tolerance, a “Waiting for stable”
message appears.
10. Hold the range pole for more than 2 seconds and the point will
automatically begin measuring.
11. When the countdown timer disappears, tilt the range pole outside of
the tilt tolerance, and then move to next point to continue.
12. To exit the Auto Measure mode, tap button.
6.3.2. SURVEY WITH TILT SENSOR
The i80 receiver is integrated with tilt sensor, which allows the use of
eBubble (electronic bubble) and tilt compensation. The tilt compensation
allows the collection of points even when the receiver is tilted up to 30
degrees off plumb. When the terrain or structures around the point do not
allow full plumbing of the receiver, the built-in tilt sensor will compensate

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English