CHC i80 User Manual

5. Rover station setup and operation
i80 GNSS Receiver User Guide  Page 43
 To continue to survey at centimeter precisions, the rover must
continuously track at least four satellites that the base station is also
tracking. The radio link between the base and rover receivers must also
be maintained.
 Loss of the satellite signals will result in a loss of centimeter position
precision.
5.2. ROVER STATION SETUP
1. If required, connect the radio antenna onto i80 receiver.
2. Screw the receiver on top of the range pole.
3. Fix the controller bracket on the range pole.
4. Fit the controller in the controller bracket.
5. Level and plumb the receiver over the target measuring point.
5.3. CONFIGURING THE ROVER STATION VIA LANDSTAR 6
SOFTWARE
5.3.1. RECEIVING CORRECTIONS USING INTERNAL RADIO MODEM
1. Power on the receiver.
2. Turn on the controller → run LandStar 6 → create a new project or open
an existing project → establish the connection with receiver via
Bluetooth or Wi-Fi (see 2.7. Connecting to a controller for the

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English