CHC i80 User Manual

5. Rover station setup and operation
i80 GNSS Receiver User Guide  Page 44
operations).
3. After successful connection, tap Rover Config in the Device screen.
4. In Rover Config screen, configure the related parameters from the
dropdown list or enter the value with the soft keyboard: Data Format,
Elevation Mask, PDOP Limit, Safe Mode and Iono Condition.
Note – Select the Data Format the same as that of base receiver.
5. Configure the antenna parameters as follows:
Type field: tap next to Type field to select CHCi80 as antenna type.
Measure To field: select Bottom from the dropdown list.
Height field: enter the height (in meters) of the range pole you are
using.
6. If required, tick Warning when base changed option → tap in the
lower right corner to save the settings and go back to Device screen.
7. Tap Communication Mode → select Radio for Mode field.
8. Configure the radio parameters as follows:
Protocol field: select the protocol the same as that of base station.
Freq field: select the frequency the same as that of base station.
Tip – Users can select a radio channel from the dropdown list. The frequency
of channel 1 to 9 is predefined; however, the frequency of channel 0 is
editable.
Baud field: select the baud rate the same as that of base station.
Power field: select the power from the dropdown list according to your

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English