To Next Page

To Previous Page

6. Survey with LandStar 6 software

i80 GNSS Receiver User Guide  Page 57

Note – Users can configure the Tilt Tolerance option to define the maximum

radius that the receiver can tilt and be considered in tolerance. The allowable

range is 0.001m to 1.000m. And the maximum tilt angle is calculated by

arctan(Tilt Tolerance/antenna height).

5. If the settings of the selected measurement method have been

changed, tap button in the lower right corner of the Survey Option

screen to save the change and go back to the Point Survey screen.

6. Tap button in the tool bar to display the eBubble.

7. Tap button → a “Waiting to move” message appears over the

eBubble → tilt the range pole (exceeding the specified tilt tolerance).

8. A “Waiting for level” message appears over the eBubble → move the

receiver to the target measuring point → level the range pole.

Other manuals for CHC i80

Questions and Answers:

Need help?

Do you have a question about the CHC i80 and is the answer not in the manual?

General