CHC i80 User Manual

6. Survey with LandStar 6 software
i80 GNSS Receiver User Guide  Page 56
measurement method in the pop-up Survey Option screen.
 The auto measure function is available for three measurement
modes: Topo Mode, Rapid Mode and Compensated Mode (require
the calibration of tilt sensor beforehand, see 6.3.2. Survey with tilt
sensor for reference).
When untick Auto measure in the Survey Option screen:
5. If the settings of the selected measurement method have been
changed, tap button in the lower right corner of the Survey Option
screen to save the change and go back to the Point Survey screen.
6. Tap button, hold the range pole until the countdown timer
disappears, and then move to next point to continue.
When tick Auto measure in the Survey Option screen:

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English