Chef's Choice 681 - Pouring and Restarting

4
• Ashortpowersupplycordisprovidedwiththisappliancetoreducetheriskofsomeonebecomingentangledinor
tripping over a longer cord and causing the Kettle to overturn, discharging its hot contents. While EdgeCraft does
not recommend it, extension cords are available and may be used if care is exercised in their use. If an extension
cord is used, it should be a grounded three conductor cord rated at not less than 15 amperes and match the
configuration of the plug. The longer cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on or tipped over by children or the infirm.
• Plugbaseunitintoathreewaygrounded110-120volt,ACoutlet.
• TheKettlepowerswitch(5)has2positions-“ON”(I)and“OFF”(O).PlaceKettleonit’sbaseandpushtheswitch
down to the “ON” position. The switch will illuminate to indicate the power is on.
• TheKettlenormallyswitchesoffautomaticallywithinabout30secondsaftertheboilingpointisreached.
• ThetimerequiredfortheKettletoautomaticallyswitchoffaftertheboilingpointisreachedwillvarydependingon
the amount of water in the Kettle; it will switch off faster after boiling if filled to its “maximum” level than if filled to
only a minimum level.
• Ifonlywarmwaterisdesired,youcan
interrupt the heating procedure at any time
by simply lifting the kettle off of its power
base. The power switch will shut “OFF”. In
order to restart the heating place the kettle
on its power base and depress the ON/OFF
switch. The switch will light indicating that
the power is on.
• TheKettlecanbeliftedeasilyfromthebase
for pouring or serving. The pouring spout
has been specially designed to easily pour
even small amounts of water.
• ReplacetheKettleonthebaseunitwhen
finished pouring.
• Wheneverthekettleisliftedoffitsbasethe
power switch must be pushed down to the
“ON” position again if you wish to restart the
heating of the water. Always check the water
level before turning the power switch “ON”.
Make certain there are at least three cups
(0.7 liters) of water in Kettle before turning
switch “ON”. Avoid boiling the kettle dry.
Figure 1.
7
8
9
4
10
1
2
5
6
3
1. Lid
2. Lid Release Button
3. Water Level Gauge
4. Base Unit
5. Illuminated Power Switch
Pull up to power “OFF”
Push down to power “ON”
6. Handle
7. Spout
8. Stainless Steel Body
9. 360° Power Connector
10. Filter Screen