PRESSPRESS
Pull the shoulder straps upwards to
remove the whole harness then pull
the adjuster strap until the harness
is fully tightened.
To release the harness (see point AD
JUSTING THE SHOULDER HEIGHT), press
the red button on the buckle downwards.
The harness should be adjusted as
tightly as possible without causing
discomfort to you child.
Tighten the shoulder harness
SECURING THE INFANT CARRIER
Please read the operating handbook in your vehicle to inform yourself
about the basics concerning children’s seat in vehicle .
DO NOT place this baby seat on seat with front airbgs.
This baby car seat can only be installed using a three-point vehicle
belt.
The baby car seat must be installed rearwards facing (in the direction
opposite the one in which you are traveling) .
Step 1: Adjust the handle to the
upright position .Place the child
safety seat on the vehicle's seat
ensuring it is firmly pressed
against the car seat backrest.
Step1
6
5
Step2. Slide the lap belt of the vehicle’s 3-point seatbelt through
both Lap belt guides .Let the tongue plate snap in the belt lock with
a clearly audible ”click”.Pull the shoulder belt in arrow direction
to tighten the lap belt.Check to make sure the tongue plate is locked
by pulling on the belt .
Step3.Place the diagonal belt in thediagonal belt guide at the back
of the seat
Step4.Tighten the vehicle’s own 3-pointseatbelt by pulling hard on
the positions .
click
Step 5 : Adjust the handle to the forward position .Place the child
safety seat on the vehicle's seat ensuring its handle must be firmly
against the car seat backrest.
The satisfactory position of the adult safety-belt buckle relative to
the child car seat is as the following picture. You can contact the
child car seat manufacturer if in doubt about this point.
Step2 Step3
Step4 Step5
To Next Page
Loading...