press
ADJUST THE HANDLE
Make sure all the belts` position is right and they has not become
twisted. Also check that the cover is not impeding the movement or
fit of the belt webbing in any way.
To release your baby car seat following the above instructions in
reverse order.
The handle for the baby car seat can
be adjusted into 4 stable positions.
To adjust the handle ,please press
the red button of handle on both sides
at the same time .Now it can be
adjusted.
The carry handle has four positions:
1.Forward facing installed in the car .This position (only this position)
is suitable for the baby car seat installed on the vehicle seat .
2.Straight up for carrying .
3.Handle clicked back to initiate the rocking feature .
4.Down to support baby for feeding and play .
Ensure that the handle is locked in a position ,the harness is
correctly fitted and buckle fastened before carrying your car seat.
2 3
4
1
7
8
1. Adjust the handle to the position same as the following picture
2. Insert frame through sleeve of canopy.
3. Insert both ends of canopy frame into the canopy frame joint
parts which locate on the both side of the car seat and above the
handle.
4 Fix the bottom of the canopy cover to the top of the car seat back,
see the following picture.
5. Rotate the canopy frame joint parts and the canopy will reach the
proper position you want.
6. Rotate the handle and the handle will reach the proper position
you want.
When you do not need canopy just take off it in reverse order of the
above instruction.
CANOPY ASSEMBLY
1
2
3
4
5
6
To Next Page
Loading...