Training Center of After-Sales Department Chery International
13. Audio system
215
1. General description
Activation
of
no disc
navigation
1. Only when BAT is charged, the system will be controlled via internal logic
of the device. When the logic is set “ON”, the audio device can work for
half of an hour when BAT is charged, and thereafter, the navigation
system will be automatically stopped, and it can be switched on again
via POWER SWITCH.
2. When both BAT and ACC are charged, the system can be activated
via POWER SWITCH and work in a long period.
3. When ACC is charged and R gear signal is valid, the system will
be activated automatically.
4. When Bluetooth device is connected and the key is at ACC, upon
the receipt of the incoming call from the connected phone, the system will
be activated automatically.
5. When ACC is charged and AC signal is received, the screen will be lit
and if the AC is not operated within 5s and the navigation device is
not activated, the screen will be off.
6. Upon the receipt of trigger conditions, relevant symbols will be indicated
within 0.5s, and the sound output will be made within 2s.
To Next Page
Loading...
