Training Center of After-Sales Department Chery International
2. PEPS system
29
Starting switch
The starting switch is located at a noticeable position on the dashboard, used to change the
car power supply mode and control the starter.
The LED indicator lamp is lit (green):
Startup conditions are met, and engine can be started by press starting switch.
No. Conditions and actions
Initial power
supply mode
New power supply
mode
1
Key is in the car, brake pedal is not
depressed (CVT), starting switch is pressed.
OFF ACC
2
ACC IGN
3
IGN OFF
4
Key is in the car, brake pedal is depressed
(CVT), gearshift lever is at P/N gear (CVT );
the starting switch is pressed.
OFF IGN+ engine startup
5
ACC IGN+ engine startup
6
IGN IGN+ engine startup
2. System elements introduction
The indicator lamp is not lit:
The power supply mode is OFF and the brake pedal (CVT car) is not
depressed or the engine has been started or is being started.
The indicator lamp is lit (amber):
The power supply mode is ACC or IGN, brake pedal (CVT car)
To Next Page
Loading...
