Chevrolet 1993 Corvette User Manual

Features & Controls
PASS-K~Y'"~(CC~NTJ
The.ignition key must be clean-and dry
before it's inserted-in the ignition or the
engine
may not start. If the SECURITY
light comes on, the key may be dirty or
wet.
If this happens and the starter.won't
work; turn the ignition off. 'Clean and
dry tkkey, wait three ,minutes and try
again. If the starter still won't work,
wait
three minutes and try the other
iation key. At this time, you may also
want to &e& the' fuse&. (see the Index
under Fuses C Circuit Brg~kers). I€ the
.-
staer won't work with the other key,
ymr vehicle needs service. If your
vehicle does start, the fkst ignition key
may be faulty. See your Chevrolet
d.ealer
or a locksmith who. can service
the PA.SS-Kcy;"
... 56
-
~
However, if you accidentally use a key
that has a damaged or missing.resistor
pellet,
you will see no SECURITY
light. You don't have to wait three.
minutes before.trying the proper key.
If the -resistor pellet is damaged m
missing, the-starter won't work. Use the
other ignition key, and see your
Chevrolet dealer or-a locksmith who
can service the PASS-Key" to have a
new key made.
If the SECURITY light comes on while
dri+ing, have your vihicle serviced 'as
suon as possible.
If you lose or damage a PASS-Key'"
ignition key, see .your Chevrolet dealer
or a locksmith who can service PASS-
Key. TM
Engine Power Key
(LT5 ENGINE ONLY)
.This key is used in the engine power
switch. -See the Index under Engirie
Power Switch.

Chevrolet 1993 Corvette Specifications

General

Brand	Chevrolet
Model	1993 Corvette
Category	Automobile
Language	English