Cleaning
the
Inside
of
Your
Vehicle
Use
a
vacuum cleaner
often
to get rid of dust and loose dirt. Wipe
vinyl
or
leather with
a
clean, damp cloth.
Your
GM
dealer has two
GM
cleaners,
a
solvent-type spot lifter and
a
foam-type powdered cleaner. They will clean normal spots and stains very
well.
Do
not use them
on
vinyl
or leather.
Here are some cleaning tips:
Always read the instructions
on
the cleaner label.
Clean up stains
as
soon
as
you can
-
before they set.
Use
a
clean cloth or sponge, and change to
a
clean area often. A soft
brush may be used if stains are stubborn.
Use solvent-type cleaners
in
a
well-ventilated area
only.
If
you use
them, don’t saturate the stained area.
If
a
ring forms after spot cleaning, clean the entire area immediately or
it
will set.
Using
Foam-Type Cleaner
on
Fabric
Vacuum and brush the area
to
remove any loose dirt.
Always clean
a
whole
trim panel or section.
Mask
surrounding trim
Mix
Multi-Purpose Powdered Cleaner following the directions
on
the
along stitch or
welt
lines.
container label.
Use
suds
only
and apply with
a
clean sponge.
Don’t saturate the material.
Don’t rub
it
roughly.
As
soon
as
you’ve cleaned the section, use
a
sponge to remove the
suds.
Rinse the section
with
a clean, wet sponge.
Wipe off what’s left with
a
slightly damp paper towel or cloth.
Then dry
it
immediately
with
a
blow dryer or
a
heat lamp.
NOTICE:
Be careful.
A
blow
dryer
may
scorch the fabric.
Wipe with
a
clean cloth.
To Next Page
Loading...
Need help?
General
