Playing
a Cassette
Tape
With the ignition and radio on, insert a cassette tape.
The
tape will begin playing as soon as it is inserted.
Press EJECT or RECALL to load a tape with the
ignition
off.
Then insert the cassette tape. A tape symbol
is shown in the center
of
the graphic display whenever a
tape is inserted. When a tape is active, the tape symbol
will be accompanied by a direction arrow.
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that are
so
thin they may not work well in this player.
The longer side with the tape visible should face to the
right.
If
you hear nothing or
hear
just a garbled sound, it
may not be in squarely. Press
EJECT
to remove the tape
and start over.
While
the
tape
is playing,
use
the
VOLUME,
FADE,
BAL, TREB,
BASS
and
TONE
controls just
as
you do for
the
radio.
The display will show
an
arrow to show which
side of the tape is playing. When the down indicator arrow
is lit, selections listed on the bottom side of the cassette are
playing. When the up arrow is lit, selections listed on the
top side of the cassette are playing.
REV
(TUNE):
Press the left
arrows
to reverse the tape
rapidly. Press
REV
(TUNE)
or
TAPE
to
return
to
playing speed.
FWD
(TUNE):
Press the right arrows to advance
rapidly to another part
of
the tape. Press
FWD
(TUNE)
or TAPE to return to playing speed.
PREV
(SEEK):
Press the left arrow to
go
to the start of
the current selection if more than eight seconds have
played. If you hold the button or press it more than once,
the player will continue moving back through the tape.
Press the left arrow or TAPE to return to playing speed.
NEXT (SEEK):
Press the right arrow to go to the
start
of
the
next selection if more
than
eight seconds have played.
If
you hold the button or press it more
than
once, the player
will continue moving forward through
the
tape.
Press the
right
arrow
or
TAPE
to return
to
playing
speed.
01
(2):
Press this button to reduce background noise
from tapes encoded with Dolby
NR.
Dolby Noise Reduction is manufactured under
a
license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
To Next Page
Loading...
