Finding
a
Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press the right or
left
arrows to
go
to a higher
or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each station tuned.
SEEK:
Press the right or left arrow to
go
to the next
higher or lower station and stay there.
Setting the Tone
BASS:
Press this knob lightly
so
it extends. Turn the
knob to the right to increase
bass
and to the left to
decrease bass.
PUSHBUTTONS:
The six numbered pushbuttons
let you return to your previously played stations.
You
can set up to
18
stations (six
AM,
six
FM1
and six
FM2).
Just:
1.
Turn the radio on.
2.
Press
AM.FM
to select the band.
3.
Tune in the desired station.
4.
Press and hold one of the six pushbuttons for at least
two seconds. The sound will mute and then return
when the station is stored. Whenever you press that
numbered button, the station you set will return.
5.
Repeat the steps for each pushbutton.
TREB:
Press this
knob
lightly
so
it extends. Turn the
knob to the right to increase treble and to the left to
decrease treble.
If
a station is weak or noisy, you may
want to decrease the treble.
Push
these knobs back into their stored positions when
you’re not using them.
TONE:
Press this button to choose preset bass and
treble equalization settings designed for ROCK,
NEWS,
POP,
JAZZ and CLASSIC. ROCK will appear when
you
first press
TONE.
Each time
you
press it, another
setting will appear on the display.
If
you press it one
more time, after CLASSIC appears
on
the display, tone
control will be back to the
BASS
and TREB knobs.
3-12
To Next Page